50 ml
How to Use Scorching Gel
Create beautifully burned designs on raw wood using your favourite stencil and a heat gun.
What You'll Need
Raw, unsealed wood
Stencil
Scorching Gel
Stencil brush
Heat gun (1800W or higher recommended)
Dry paper towel
Step 1: Prepare the Wood
Sand the wood until smooth (220-grit is recommended) and remove all dust. The surface must be raw and unsealed. Varnishes, oils, waxes, and paints will prevent the gel from reacting properly.
Step 2: Apply Your Stencil
Secure your stencil firmly to the wood surface to prevent movement and ensure crisp results.
Step 3: Apply the Scorching Gel
Using an stencil brush, dry brush a thin, even layer of Scorching Gel over the stencil design. A thin coat works best and helps prevent bleeding under the stencil.
Step 4: Remove the Stencil & Allow to Dry
Carefully lift the stencil and allow the gel to dry completely. Drying time is typically around 20 minutes, depending on temperature and humidity. The gel should no longer appear wet or glossy.
Step 5: Apply Heat
Using a heat gun (1800W or higher), hold the nozzle approximately 5–10 cm from the surface. Keep the heat gun moving continuously in sweeping or circular motions. As the gel reacts to the heat, the design will gradually darken to create a scorched effect.
Step 6: Finish
Allow the wood to cool completely. Wipe away any residue with a dry paper towel. If desired, apply a suitable sealant or food-safe oil once the project is fully cooled.
Tips for Best Results
✔ Use only on raw, untreated wood.
✔ Apply a thin layer of gel.
✔ Keep the heat gun moving at all times.
✔ Test on a scrap piece of wood before starting your project.
✔ Results may vary depending on the wood species.
* Brushes and stencils can be cleaned with warm soapy water.
Note: This product will not damage your stencil, but it’s best to clean the stencil immediately after use.
Warning: Use in a well-ventilated area. Avoid inhaling fumes generated during heating. Keep out of reach of children. Wear appropriate eye and hand protection when using heat tools. Do not use near open flames. Results may vary depending on wood type.
